Mableton, GA · Cobb County
Hardwood Floor Refinishing in Mableton, GA
If your floors in Mableton are scratched, dull, gray or just the wrong color, I can bring them back. I'm Cristobal and I've been doing floors around metro Atlanta for years.
I can usually start within a few days. Call or text Cristobal at 404-796-7650.
Floors I work on in Mableton
Older ranches with oak under carpet and a lot of renovations and flips going to LVP.
I work all over Mableton: Floyd Rd, Veterans Memorial Hwy, near Six Flags and Mableton Pkwy, plus zip codes 30126.
Recent floors around Mableton



Real photos from my jobs.
What I do in Mableton
- Hardwood floor refinishing: full sand to bare wood, repairs, your stain color, 3 coats of finish. Stairs and handrails too.
- Hardwood installation: solid and engineered, site-finished or prefinished, nail-down or glue-down.
- LVP & laminate: waterproof vinyl plank for kitchens, baths, basements and whole houses.
- Tile: porcelain and ceramic floors, wood-look tile, showers and backsplashes.
How it works
- Text me photos of the floor and the rough square footage.
- I give you a price and come look at it in person if needed.
- You pick the stain. I put down samples right on your floor so you see the real color.
- I do the job, clean up, and you get your house back.
Common questions
How much does it cost to refinish hardwood floors in Mableton?
Most refinishing jobs in Mableton land around $3 to $5 per square foot depending on the stain color, repairs, and whether stairs are included. Send me photos and the square footage and I'll give you a real number.
How long does refinishing take?
A typical 500–800 sq ft job takes 3 to 4 days: one day to sand, stain the next, then coats of finish. You can walk on it in socks after about 24 hours and put furniture back after 3–4 days.
Do you work in Floyd Rd and Veterans Memorial Hwy?
Yes. I work all over Mableton, including Floyd Rd, Veterans Memorial Hwy, near Six Flags, Mableton Pkwy, and the rest of Cobb County.
Can my floors be refinished or do they need to be replaced?
Solid hardwood can usually be sanded several times. Engineered floors depend on the wear layer. If you're not sure, text me a photo of the floor and the edge of a board (at a vent or doorway) and I'll tell you.