Riverdale, GA · Clayton County
Hardwood Floor Refinishing in Riverdale, GA
I'm Cristobal, and I refinish and install floors in Riverdale and around Clayton County. When you call, you talk to me, and I'm the one who shows up to do the work.
I can usually start within a few days. Call or text Cristobal at 404-796-7650.
Floors I work on in Riverdale
1970sā90s homes and rentals, mostly LVP and laminate replacing carpet, with refinishing where there's oak.
I work all over Riverdale: Hwy 85, Upper Riverdale Rd, Church St and Valley Hill Rd, plus zip codes 30274, 30296.
Recent floors around Riverdale



Real photos from my jobs.
What I do in Riverdale
- Hardwood floor refinishing: full sand to bare wood, repairs, your stain color, 3 coats of finish. Stairs and handrails too.
- Hardwood installation: solid and engineered, site-finished or prefinished, nail-down or glue-down.
- LVP & laminate: waterproof vinyl plank for kitchens, baths, basements and whole houses.
- Tile: porcelain and ceramic floors, wood-look tile, showers and backsplashes.
How it works
- Text me photos of the floor and the rough square footage.
- I give you a price and come look at it in person if needed.
- You pick the stain. I put down samples right on your floor so you see the real color.
- I do the job, clean up, and you get your house back.
Common questions
How much does it cost to refinish hardwood floors in Riverdale?
Most refinishing jobs in Riverdale land around $3 to $5 per square foot depending on the stain color, repairs, and whether stairs are included. Send me photos and the square footage and I'll give you a real number.
How long does refinishing take?
A typical 500ā800 sq ft job takes 3 to 4 days: one day to sand, stain the next, then coats of finish. You can walk on it in socks after about 24 hours and put furniture back after 3ā4 days.
Do you work in Hwy 85 and Upper Riverdale Rd?
Yes. I work all over Riverdale, including Hwy 85, Upper Riverdale Rd, Church St, Valley Hill Rd, and the rest of Clayton County.
Can my floors be refinished or do they need to be replaced?
Solid hardwood can usually be sanded several times. Engineered floors depend on the wear layer. If you're not sure, text me a photo of the floor and the edge of a board (at a vent or doorway) and I'll tell you.