Union City, GA · Fulton County
Hardwood Floor Refinishing in Union City, GA
My name is Cristobal. I sand, stain and refinish hardwood floors in Union City, and I also install hardwood, LVP, laminate and tile all over Fulton County.
I can usually start within a few days. Call or text Cristobal at 404-796-7650.
Floors I work on in Union City
1990s and 2000s homes and a lot of rentals. LVP installs and refinishing builder oak are the most common jobs.
I work all over Union City: Jonesboro Rd, Flat Shoals Rd, Hwy 138 and Shannon Pkwy, plus zip codes 30291.
Recent floors around Union City



Real photos from my jobs.
What I do in Union City
- Hardwood floor refinishing: full sand to bare wood, repairs, your stain color, 3 coats of finish. Stairs and handrails too.
- Hardwood installation: solid and engineered, site-finished or prefinished, nail-down or glue-down.
- LVP & laminate: waterproof vinyl plank for kitchens, baths, basements and whole houses.
- Tile: porcelain and ceramic floors, wood-look tile, showers and backsplashes.
How it works
- Text me photos of the floor and the rough square footage.
- I give you a price and come look at it in person if needed.
- You pick the stain. I put down samples right on your floor so you see the real color.
- I do the job, clean up, and you get your house back.
Common questions
How much does it cost to refinish hardwood floors in Union City?
Most refinishing jobs in Union City land around $3 to $5 per square foot depending on the stain color, repairs, and whether stairs are included. Send me photos and the square footage and I'll give you a real number.
How long does refinishing take?
A typical 500–800 sq ft job takes 3 to 4 days: one day to sand, stain the next, then coats of finish. You can walk on it in socks after about 24 hours and put furniture back after 3–4 days.
Do you work in Jonesboro Rd and Flat Shoals Rd?
Yes. I work all over Union City, including Jonesboro Rd, Flat Shoals Rd, Hwy 138, Shannon Pkwy, and the rest of Fulton County.
Can my floors be refinished or do they need to be replaced?
Solid hardwood can usually be sanded several times. Engineered floors depend on the wear layer. If you're not sure, text me a photo of the floor and the edge of a board (at a vent or doorway) and I'll tell you.